The solar garden light is an independent self-powered system. When installing the solar maintenance-free battery, it should be handled gently when placed in the control box to prevent damage to the control box; the connection between the batteries must be bolted to the battery. On the terminal, and use copper gasket to enhance its conductivity; after the output line is connected to the battery, it is forbidden to short-circuit under any circumstances to avoid damage to the battery. When the output line of the battery is connected with the controller in the pole Must pass the PVC threading pipe. After completing the above steps, check the wiring of the controller to prevent short circuit. After normal, close the door of the control box.
Installation of the solar garden light fixture requires fixing of the components of each part: the solar panel is fixed on the solar panel bracket, the lamp cap is fixed to the pick arm, then the bracket and the pick arm are fixed to the main pole, and the connecting line is guided to the control Box (battery box). Before lifting the pole, first check whether the fasteners in each part are firm, whether the lamp is installed correctly, and whether the light source works normally.
Then, if the debugging system works normally, loosen the connection line with the solar panel on the controller, the light source works normally, and the solar panel connection line light is turned off; at the same time, the changes of the indicators on the controller are carefully observed, so the data belongs to Normal, it can be lifted and installed.
When the main pole is hoisted, pay attention to safety precautions. The screws must be fastened. If the component has a deviation from the sun-facing angle, it needs to be adjusted to the south-facing direction.
Put the battery into the battery box, connect the cable to the controller according to the technical requirements, connect the battery first, then connect the load, and then connect the solar panel. When wiring, be sure to pay attention to the wiring and the terminal marked on the controller. If the error is wrong, the positive and negative polarities cannot collide and cannot be reversed, otherwise the controller will be damaged.
Perform the debugging system again to run normally; release the solar panel connection line on the controller, the solar garden light source is bright, connect the solar panel connection line, the light goes out; at the same time carefully observe the changes of the indicators on the controller, so The data is normal before the control box can be sealed.
Ceramic Soup Plate,Storage Jars Ceramic,Embossment Stone Ware,Color Glaze Storage Jars
HANDAN OURAY I/E CO., LTD , https://www.ourayceramicware.com